KMV 10    
    A DC voltage measuring amplifier for sensors with DMS system. Mounted preferably close to the sensor it converts the output voltage of the measuring
bridge into a standard voltage for distant signal interpretation.
With potentiometers for zero setting and sensor calibration. Sensor and output connexions are
made by the provided connector. The KMV 10 can be connected with voltage supply sources of the
machine control system. For feeding the DMS measuring bridge it provides a highly constant
supply voltage.
   2 KMV 10, without illustration, as
KMV 10 however with 2 amplifiers
in one housing.
 
      MV 110    
   

Measuring amplifier for DMS measuring systems, Europe board size 100x160 mm, for installation
in 19“ subrack. Applied for measuring and control.
Adjusting zero-point and amplifying on front panel. The MV 110 - 2 contains two measuring amplifiers independent of each other and also an adder which adds up both input signals. The output signals are available by the check plug socket on the front panel. A highly constant supply voltage is available for loading the DMS measuring bridge.

   
 
      SA 310 DMS    
    Digital built-in display device for connecting sensors with DMS measuring bridge applied for measuring andcontrolling. The output signal is available by the
check plug socket on the front panel. Adjusting zero-point, amplifier and damper on the
front panel.
A highly constant supply voltage
is available for loading the DMS measuring bridge. Option: alarm
output via optocoupler.SA 310 (without illustration) as SA 310-DMS, however for connecting capacitive Tensometric sensors
or DMS sensors with built-in
measuring amplifier.		  

SA 310 (without illustration) as
SA 310-DMS, however for
connecting capacitive Tensometric
sensors or DMS sensors with
built-in measuring amplifier or
amplifier KMV 10.
 
      SA 610    
    Digital built-in display device for connecting sensors with built-in measuring amplifier or DMS systems.
All-round applicable by programmable functions. With
MIN-MAX display, storage and
MIN-MAX relay, serial
interface,taring, filtering, synchronization with
production process et all.		    
 
      Mini 710    
   

Portable, smart, small electronic tensile force display device. For connecting capacitive Tensometric
tensile force sensors. Digital display : direct reading of
measured tensile force. With analog output signal 0-1 V. At the push of a button the last indicated
measuring value is held. Battery operated.

 

Measuring ranges:

Depending upon connected
sensor.

The device recognizes the
connected sensor and shows
correctly the measured tensile
force.

Available accessories:
Storage battery and charger.
 
      MEMO DT 905    
    Comfortable electronic tensile force display device with integrated microprocessor. For connecting capacitive Tensometric tensile force
sensors. Storage capacity for 800 measurements.
Simultaneous digital display of actual value, average, peak value. Automatic statistical values calculating.		   Analog output signal 0 - 10 V
and serial interface RS 232
are standard.

For mains and storage operation.

Built-in charger. Particularly
suitable for monitoring according
to DIN 9000
 
      PID- 48    
    Small, very efficient PID control unit with many functions, such as self-optimisation, MIN-MAX - alarm, serial interface et al. Easy handling.