Measuring ranges:
0-2daN/cm, 0-5daN/cm,
0-10daN/cm, 0-20daN/cm
Measuring roller width: 25mm
Guide roller width: 300mm
0-2daN/cm, 0-5daN/cm,
0-10daN/cm, 0-20daN/cm
Measuring roller width: 25mm
Guide roller width: 300mm
the tension forces of warp threads.
A special mechanism enables the threading of warp threads, even when threads are close together.
The total force of a warp up to a maximum width of 50 mm is measured and indicated on a separate gauge.
The streight design of the unit allows the measurement of tensions even at the edges of the warp.The unit is versatile, measurements of the running warp may be taken vertically or horizontally.
Type STAK 1390 is a compact, precise and reliable measuring head for
measuring tensile and compressive forces. It contains all necessary components
for measurements in a very flat housing:- Measuring system- amplifier
with analog output- zero point setting (tare)- adjustment for amplifying
(calibration).
It is easy to fix it in its place of measurement, and it is ready for operation immediately. Fixing the sensor is optional, several sensors can be grouped in one block.
STAK 1390:
0-2N, 0-3N, 0-4N, 0-5N, 0-6N,
0-10N, 0-20N, 0-30N
STAK 1390-C:
0-30N, 0-50N, 0-100N, 0-200N,
0-300N, 0-400N, 0-500N
With built-in measuring amplifier. zero point setting (taring)
and amplification (calibration).
Analog output signal: 0 - 10 V
Equipped with 3 hardwearing ceramic thread guides. Very slim design, stackable.
Thread tension measurement for analysis of thread tension flow, e.g. of weft threads of looms during production or for laboratory use. Records thread tension peaks in millisecond range - automatic zero-point setting - averaging in selectable time interval -interface RS 232 - analog output - 20 sensor calibrations and 800 measurements can be stored.
These measuring heads are equipped with extra large guide and measuring rollers in order not to damage materials sensitive to bending during tensile force measuring. The deflection of the material to be measured is kept to a minimum.
Electronic tensile force measuring device. Equipped with rollers of 50 mm diameter and therefore suitable for measuring fiber optic cable. minimum deflection of material to be measured.
Direct reading of measured tensile force. Display damping can be activated, i.e. stable and smooth indication even during fluctuating tensile forces. At the push of a button the last indicated measured value will be held.
Nominal load: 20N (2000cN)
Solution: 0,01N (1cN) steps
Measuring range: 0-20N
Battery operated
Available accessories:
Storage battery and charger
Radial force sensor series M 1391 can be equipped with measuring
cylinders up to a width of 230 mm. So the tensile forces can be
measured. The measurement is independent of lever arm. For installing
in machines.
According to your requirements
Maximum measuring width: 230 mm
The M 161 has been developed for tensile force measuring of ribbons, cords, strips and continuous webs. The special configuration of guiding and measuring rollers enables the user to press the sensor on the material for measuring. Threading the material to be measured is not necessary. Suitable as hand device or for installing in machines.
7 versions from 0 - 50 mm to
0 - 400 mm are available.
Measuring ranges:
from 0 - 10 daN to 0 - 400 daN